- (A) 2% Potassium sulfate
- (B) 0.2% Potassium sulfate
- (C) 2% sodium sulfate
- (D) 4% Potassium sulfate
Medical Mcqs
- (A) After the start of appearing elastic properties of impression material
- (B) Just after the start of appearing elastic properties of impression material
- (C) The time for start of mixing till just before the start of appearing elastic properties of impression material
- (D) Loss of lusture of impression material
- (A) Addition silicone < polyether < polysulfide < condensation silicone
- (B) Addition silicone < polysulfide < Polyether < condensation silicone
- (C) condensation silicone < polyether < polysulfide < Addition silicone
- (D) condensation silicone < polysulfide < polyether < Addition silicone
- (A) Impression compound
- (B) Alginate
- (C) Agar-agar
- (D) Polyether
- (A) Polysulphide
- (B) Silicone
- (C) Impression plaster
- (D) Zinc oxide eugenol paster
- (A) Zinc oxide impression material
- (B) Agar
- (C) Condensation silicone
- (D) Polyether
- (A) 20°C to 25°C
- (B) 27°C to 33°C
- (C) 37°C to 50°C
- (D) 55°C to 60°C
- (A) Gelation increase in both on increase in temperature
- (B) Mixing time is increased to reduce the setting time
- (C) Deformation during removal of impression occurs due to distortion of gel fibers
- (D) Both can be re-used for fresh impressions
- (A) Hydrocolloid
- (B) Impression compound
- (C) Elastomer
- (D) Zinc oxide eugenol
- (A) Hydrophilic
- (B) Hydrophobic
- (C) Water loving impression materials
- (D) Potassium alginates
