Electrical Engineering Mcqs

An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed________?

(A)  795mV

(B)  395mV

(C)  795 mV

(D)  39.5mV

Submitted By :Ali Uppal

---

Share this...

Facebook

Twitter

Linkedin

Whatsapp

---

IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

---

Comments:

79.5mv

Commented by: khuram shahzad

---

Related Mcqs

In water treatment, alum [Al2(SO4)3] is used for the process of __________________?

Which of the following is not a secondary air pollutant ?

Which of the following dust collection equipments is the least efficient (for sub-micronic particles) ?

Shouting by a man at his full voice corresponds to a voice level of about _____________ decibels?

Acute danger to human life (i.e. death) exists, if the concentration of CO2 in atmospheric air exceeds ______________ percent (by volume)?

---

Leave a Reply

Your email address will not be published. Required fields are marked *