Chemical Engineering Mcqs

Half the angle of nip, (α), for a roll crusher is given by (where, dr, dp and df are diameters of crushing rolls, feed particles and rolls gap respectively) ?

(A)  cos α = (dr + dp)/(dr + df)

(B)  cos α = (dr + df)/(dr + dp)

(C)  tan α = (dr + dp)/(dr + df)

(D)  sin α = (dr + dp)/(dr + df)

Submitted By :Ali Uppal

---

Share this...

Facebook

Twitter

Linkedin

Whatsapp

---

IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

---

Related Mcqs

A diesel engine as compared to petrol engine (both running ar rated load) is ____________________?

Most high speed compression engines operate on ___________________?

The cam shaft of a four stroke I.C. engine running at 1500 rmp will run at __________________?

The term scavenging is generally associated with______________________?

Fuel consumption of diesef engines is not guaranteed at one quarter load because at such low loads________________?

---

Leave a Reply

Your email address will not be published. Required fields are marked *