Get App on

Play Store

Mechanical Engineering Mcqs

The shrinkage allowance for cast iron pattern is________________?

 (A)  15 mm/m

 (B)  20 mm/m

 (C)  26 mm/m

 (D)  10 mm/m

Submitted By :Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • LMTD correction factor is used in heat exchanger design for____________________?
  • A binary liquid Azeotropic mixture has boiling point higher than either of the components, when it shows ______________ deviation from Raoult’s Law?
  • Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate ?
  • Cooling water fouling factors vary in the range of 0.001 to 0.003____________________?
  • A cylindrical storage tank can have a self supported conical roof ?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON