Mechanical Engineering Mcqs

PERT stands for k (fit) project evaluation and review technique__________________?

(A)  project examination and review technique

(B)  project evaluation and reporting technique

(C)  process execution and reporting technology

(D)  project execution and results technique

Submitted By :Ali Uppal

---

Share this...

Facebook

Twitter

Linkedin

Whatsapp

---

IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

---

Related Mcqs

Berl saddle made of carbon cannot be used for ___________________?

For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of _______________ microns (1 mm = 1000 microns)?

If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is___________________?

Corresponding to Prandtl number in heat transfer, the dimensionless group in mass transfer is the _______________ number?

Physical absorption is__________________?

---

Leave a Reply

Your email address will not be published. Required fields are marked *