Get App on

Play Store

Mechanical Engineering Mcqs

Lancing is the operation of _________________?

 (A)  cutting a sheet of metal through part of its length and then bending the cut portion

 (B)  removal of metal to the desired shape from the edge of a plate

 (C)  cutting a sheet of metal in a straight line along the length

 (D)  bending a sheet of metal along a curved axis

Submitted By :Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • In a multipass shell and tube heat exchanger, the baffles on shell side is primarily provided for______________?
  • The thickness of segmental baffles (25 -35% cut truncated plates usually) is generally _____________ the tube wall thickness?
  • LMTD correction factor is used in heat exchanger design for____________________?
  • A binary liquid Azeotropic mixture has boiling point higher than either of the components, when it shows ______________ deviation from Raoult’s Law?
  • Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate ?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON