Get App on

Play Store

Mechanical Engineering Mcqs

In order to prevent formation of carbon on the injector, the temperature of nozzle tip should be__________________?

 (A)  less than 100°C

 (B)  between 100-250°C

 (C)  between 250 – 300°C

 (D)  between 400 – 500°C

 (E)  between 500 – 1000°C

Submitted By :Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The drying time between fixed moisture contents within the ‘constant rate period’ is proportional to (assuming that drying occurs from all surfaces of the solid) (where, T = thickness of the solid) ?
  • Sticky material can be dried in a ________________ dryer ?
  • Drying operation under vacuum is carried out to __________________?
  • At equilibrium the concentration of water in vapour phase (C*) in kg/m3 of air space and the amount of water (m) adsorbed per kg of dry silica gel are related by, C* = 0.0667m. To maintain dry conditions in a room of air space 100m3 containing 2.2 kg of water vapour initially, 10 kg of dry silica gel is kept in the room. The fraction of initial water remaining in the air space after a long time (during which the temperature is maintained constant) is_________________?
  • In a counter-current extractor, as the axial mixing increases, the extraction efficiency______________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON