Mechanical Engineering Mcqs

Gas turbines for power generaion are normally used___________________?

(A)  to supply base load requirements

(B)  to supply peak load requirements

(C)  to enable start thermal power plant

(D)  in emergency

(E)  when other sources of power fail

Submitted By :Ali Uppal

---

Share this...

Facebook

Twitter

Linkedin

Whatsapp

---

IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

---

Related Mcqs

Holes of a sieve tray are arranged in triangular pitch of _________________ times the hole diameter?

Tube side pressure drop in a 1-2 heat exchanger (for turbulent flow of fluids through the tubes) is about __________ times, that in a 1-1 heat exchanger having the same size & number of tubes and operated at the same liquid flow rate ?

In a multipass shell and tube heat exchanger, the shell side cross flow area does not depend upon______________________?

Correct use of ‘factor of safety’ is very important in equipment design. It is defined as the ratio of the___________________?

For laminar flow (NRe < 2100) in steel pipe, the optimum inside pipe diameter is given by____________________?

---

Leave a Reply

Your email address will not be published. Required fields are marked *