Get App on

Play Store

Mechanical Engineering Mcqs

Francis turbine is best suited for_____________________?

 (A)  medium head application from 24 to 180 m

 (B)  low head installation up to 30 m

 (C)  high head installation above 180 m

 (D)  all types of heads

 (E)  none of the above

Submitted By :Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area ‘A’ is given by (where, P = perimeter of the channel in contact with the fluid) ?
  • The buckling tendency of compression members is always in the direction of the _____________________?
  • ____________ is the determining factor for the number of bubble caps to be used per tray?
  • Which of the following is the most common type of baffle used in industrial shell and tube heat exchanger ?
  • The clearance between two tubes in a shell and tube heat exchanger is known as ‘ligament’, whose minimum value is _____________ the outside diameter of the tube, but in no case it should be less than 4.5 mm?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON