Civil Engineering Mcqs

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than________________?

(A)  WL/12 (L – 2D/3)²

(B)  WL/10 (L + 2D/3)²

(C)  WL/10 (L – 2D/3)²

(D)  WL/12 (L – D/3)²

Submitted By :Ali Uppal

---

Share this...

Facebook

Twitter

Linkedin

Whatsapp

---

IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

---

Related Mcqs

Angled baffles are preferred in the agitation tank to control the swirling action; if the viscosity of the liquid to be mixed is about 200 poise. However, the baffle may be completely eliminated for mixing liquids having viscosity above ____________________ poise?

Which of the following efficiencies can be greater than 100% ?

Minimum tube pitch recommended for shell and tube heat exchangers is about _______________ times the outside diameter of the tube?

In a shell and tube heat exchanger, triangular pitch arrangement as compared to square pitch arrangement ?

_____________ heat exchanger is also known as ‘hair pin type’ exchanger?

---

Leave a Reply

Your email address will not be published. Required fields are marked *