Chemical Engineering Mcqs

Pick out the wrong statement pertaining to fluid flow ?

(A)  The ratio of average velocity to the maximum velocity for turbulent flow of Newtonian fluid in circular pipes is 0.5

(B)  The Newtonian fluid velocity in a circular pipe flow is maximum at the centre of the pipe

(C)  Navier-Stokes equation is applicable to the analysis of viscous flows

(D)  Hagen-Poiseuille equation is applicable to the laminar flow of Newtonian fluids

Submitted By :Ali Uppal

Share this... Share on Facebook
Facebook
 		Tweet about this on Twitter
Twitter
 		Share on LinkedIn
Linkedin
 		Share on Whatsapp
Whatsapp
  • IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

  • PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

    • Related Mcqs

  • The strain energy due to volumetric strain________________?
  • The strain energy stored in a spring when subjected to greatest load without being permanently distorted, is called______________?
  • A spring of mean radius 40 mm contains 8 action coils of steel (N = 80000 N/mm2), 4 mm in diameter. The clearance between the coils being 1 mm when unloaded, the minimum compressive load to remove the clearance, is_____________?
  • The forces acting normally on the cross section of a bar shown in the given figure introduce_______________?
  • The maximum deflection due to a uniformly distributed load w/unit length over entire span of a cantilever of length l and of flexural rigidly EI, is_________________?

    • Leave a Reply

    Your email address will not be published. Required fields are marked *

    Submit Your Mcqs


    Management Sciences


    Engineering Subjects


    Medical Subjects


    LIKE US ON