Fouling factor must be included in the calculation of overall design heat transfer coefficient, when the liquid__________________?

Chemical Engineering Mcqs

Fouling factor must be included in the calculation of overall design heat transfer coefficient, when the liquid__________________?

(A)  Containing suspended solids flows at low velocity

(B)  Containing suspended solids flows at high velocity

(C)  Is highly viscous

(D)  Is of high specific gravity

Submitted By :Ali Uppal

---

Share this...

Facebook

Twitter

Linkedin

Whatsapp

---

IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

---

Related Mcqs

• Previous:Overall tray efficiency of a distillation column is the ratio of the number of ___________________?
• Next:Pressure drop due to pipe fittings can be estimated by the equation, ΔP/ρ = 4f, (Le/D) (V2/2gc) where, Le = equivalent length of straight pipeline which will incur the same frictional loss as the fitting and D = diameter of the fitting. The value of (Le/D) (dimensionless) for 45° elbow and 180° close return bends would be respectively around______________________?

---

Leave a Reply

Your email address will not be published. Required fields are marked *