For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of _______________ microns (1 mm = 1000 microns)?
(A) 1-5
(B) 10-60
(C) 200-300
(D) > 500
For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of _______________ microns (1 mm = 1000 microns)?
| Share this... |
 Facebook
|
 Twitter
|
 Linkedin
|
 Whatsapp
|
Related Mcqs
- Previous:If G = insoluble gas in gas stream and L = non-volatile solvent in liquid stream, then the slope of the operating line for the absorber is___________________?
- Next:Berl saddle made of carbon cannot be used for ___________________?
Leave a Reply
Your email address will not be published. Required fields are marked *
