Chemical Engineering Mcqs

Failure of a material is termed as fatigue failure, if it fails below the yield point. The resistance to fatigue failure of a material is measured by the__________________?

(A)  Ultimate tensile strength (U.T.S.)

(B)  Endurance limit

(C)  Elastic limit

(D)  None of these

Submitted By :Ali Uppal

---

Share this...

Facebook

Twitter

Linkedin

Whatsapp

---

IF YOU THINK THAT ABOVE POSTED MCQ IS WRONG.

PLEASE COMMENT BELOW WITH CORRECT ANSWER AND ITS DETAIL EXPLANATION.

---

Related Mcqs

In a certain low-pass filter, fc = 3.5 kHz. If the input voltage is a 6 V sine wave with a dc level of 10 V, what is the output voltage magnitude?

An RL low-pass filter consists of a 5.6 mH coil and a 3.3 kΩ resistor. The output voltage is taken across the resistor. The circuit’s critical frequency is______________?

An RC high-pass filter consists of a 0.2 µF capacitor and a 220 Ω resistor. The output is taken across the resistor. The circuit’s critical frequency is_____________?

At a certain frequency, the output voltage of a filter is 6 V and the input is 12 V. The voltage ratio in decibels is_____________?

A dynamo converts______________?

---

Leave a Reply

Your email address will not be published. Required fields are marked *